Teeter Hang Ups FlexTech Series Assembly Instructions Manual page 14

STEP 5
FIGURE 11
FIGURE 12
1
2
1 Handle
2 Hinge Plate
FIGURE 13
1
1 Self-Locking Hook
2 Roller Hinge
Attach the Table Bed to the A-Frame
• Pick up the Table Bed, holding each side near the Roller Hinges, and stand in front of the
A-Frame where the Crossbar is located (refer to Figure 3 to determine A-Frame Front).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one side at a time
(Figure 11 and 12).
NOTE: You may need to push outward on the A-Frame in order for the 2nd Pivot Pin to
lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot of the Hinge Plate (Figure
13).
• Ensure that the Self-Locking Hooks have closed over both Pivot Pins, and that the Table
Bed rotates smoothly.
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
2
WARNING
!
could result in serious injury or death!
13