Teeter Hang Ups FlexTech Series Assembly Instructions Manual page 12

FIGURE 5
1
2
1 Support Beam
2 Upper Support Arms
FIGURE 6
STEP 3 Table Bed Assembly
• Locate the Table Bed Assembly Hardware Kit, which contains the hardware that is required
for the assembly detailed in this step.
• Place the Table Bed face down on the floor and push down on the Support Beam, so the
two holes align evenly with the holes at the base of the Upper Support Arms (Figure 5).
You may have to exert extra pressure to ensure that the Support Beam slides over the
rubber spacers.
• Insert the two Bolts into the open holes (Figure 6).
• Thread a Washer and Nut onto each Bolt and handtighten.
• Using the 6mm Allen Wrench to steady the bolts, tighten the Nuts onto the Bolts with the
10/13mm Open-Ended Wrench.
11