Checking The Hydraulic Lines And Hoses - Toro Reelmaster 7000-D Operator's Manual

1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brakes, and remove the ignition key.
2. Clean the area around the filter mounting area.
3. Place a drain pan under the filter and remove
the filter (Figure 101
4. Lubricate the new filter gasket and fill the filter
with hydraulic fluid.
Figure 101
1. Hydraulic filter
Figure 102
1. Hydraulic filter
5. Ensure that the filter mounting area is clean.
6. Screw the filter on until the gasket contacts
the mounting plate; then tighten the filter an
additional 1/2 turn.
and Figure 102).
7. Start the engine and let it run for about 2 minutes
to purge air from the system.
8. Stop the engine and check for leaks.
Checking the Hydraulic
Lines and Hoses
Service Interval: Before each use or daily
Inspect the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure that all hydraulic fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
g009723
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Seek immediate medical attention if fluid
is injected into skin.
g026706
67