Figure 23
1. Chain bracket
2. Snapper pin
7
Greasing the Machine
No Parts Required
Procedure
Before the machine is operated, it must be greased to
ensure proper lubrication. Refer to
52). Failure to properly grease the machine will result
in premature failure of critical parts.
g004144
3. Cutting-unit kickstand
Lubrication (page
8
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the level of the rear axle lubricant before
the engine is first started, refer to
Oil Level of the Rear Axle (page
2. Check the level of the hydraulic fluid before
the engine is first started, refer to
Level of the Hydraulic Fluid (page
3. Check the level of the engine oil before and after
the engine is first started, refer to
Engine-Oil Level (page
9
Using the Gauge Bar
Parts needed for this procedure:
1
Gauge bar
Procedure
Use the gauge bar to adjust the cutting unit. Refer to
the cutting unit Operator's Manual for the adjustment
procedures
(Figure
22
Checking the
62).
Checking the
34).
Checking the
55).
24).