Figure 11
1. Opposite carrier frame tab
E. Mount the rod bracket to the cutting unit
tabs with the carriage bolts and nuts
11). On the cutting unit, mount the left hose
guide to the front of the cutting unit tabs
when reinstalling the rod bracket
13).
Important:
front) and Cutting Unit 5 (right front),
use the rod-bracket mounting nuts to
install the hose guides to the front of
the cutting-unit tabs. The hose guides
should lean toward the center cutting
unit
(Figure 12
Figure 12
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1
1. Hose guides (each must lean toward the center cutting unit)
2. Rod bracket
(Figure
On Cutting Unit 4 (left
through
Figure
14).
5. Cutting unit 5
6. Reel motor
7. Weight
g003967
(Figure
1. Hose guide (left side
shown)
2. Rod bracket
g031275
Figure 14
18
Figure 13
3. Nuts
1
g015160
g019602
g019602