Checking The Hydraulic Lines And Hoses; Cutting Unit Maintenance; Separating The Mower Decks From The Traction Unit - Toro Groundsmaster 3500-D Operator's Manual

Figure 66
1. Hydraulic-tank cap
5. Install the reservoir cap.
6. Start the engine.
7. Use all the hydraulic controls to distribute the
hydraulic fluid throughout the system, check for
leaks, then shut off the engine.
8. Check the fluid level and add enough to raise
the level to the F
Note:
Do not overfill.
Checking the Hydraulic
Lines and Hoses
Service Interval: Before each use or daily
Check the hydraulic lines and hoses for leaks, kinked
lines, loose mounting supports, wear, loose fittings,
weather deterioration, and chemical deterioration.
Make all necessary repairs before operating the
machine.
mark on the dipstick.
ULL

Cutting Unit Maintenance

Separating the Mower
Decks from the Traction
Unit
1. Perform the pre-maintenance procedure; refer
to Preparing the Machine for Maintenance (page
35).
2. Remove the hydraulic-motor-mounting screws
and disconnect and remove the hydraulic motor
from the deck
g031641
Important:
prevent contamination.
1. Motor-mounting screws
53
(Figure 67).
Cover the top of the spindle to
Figure 67
g031644