Pre-Maintenance Procedures; Removing The Hood; Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 7000-D Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Pre-Maintenance
Procedures

Removing the Hood

1. Release the hood latches
open the hood.
Figure 66
1. Hood latch (2)
2. Remove the cotter pins securing the rear hood
brackets to the frame pins and lift off the hood.
(Figure 66) and pivot
g014982

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be
lubricated regularly with No. 2 lithium grease. If
the machine is operated under normal conditions,
lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
The grease fitting locations and quantities are as
follows:
•
Brake shaft pivot bearings (5)
•
Rear axle pivot bushings (2)
52
(Figure 67)
Figure 67
(Figure 68)
Figure 68
g009704
g009705