Installation and Initial Setup
IP Configuration Screen
Another press of the Right button brings you to the IP Configuration screen for the Control port.
Important!
Both the Control and AES67 connections must be connected to 1000BASE-T (Gigabit) switch ports. If a port
will not be used, it should not be connected to a switch but does require a specific configuration described
below. If both the Control and AES67 ports are used, each must be on a different subnet.
To set a fixed IP address for the Control port:
Press the Right button until the IP Configuration (Control) screen is displayed
♦
Press the OK button to highlight "Edit"
♦
Press OK again to highlight "Use DHCP"
♦
Press the Right button to highlight "Yes"
♦
Press the Up/Down button to "No"
♦
Press the Left button to highlight the "Use DHCP" field
♦
Press the Down button to highlight "Address"
♦
Press the Right button to move to the first digit of the IP address
♦
Use the Up/Down buttons to change the selection
♦
Press the Right/Left buttons to select another digit to edit
♦
When finished editing the address field, press the Right or Left button to return to "Address"
♦
Press the Down button to navigate to the Netmask and Gateway fields
♦
Repeat the above steps to edit the Netmask and Gateway fields; note that the gateway may be set to 000.000.000.000 if no
♦
gateway is required
After the gateway is set, press the Left button to highlight "Gateway"
♦
Press the Down button to highlight "Update"
♦
Figure 4-5 – Front panel IP configuration screen
Chapter 4 |
10