Table of Contents
Advertisement
INSTALLATION AND INITIAL SETUP
Setting IP Addresses
ARC ships with DHCP enabled and will automatically retrieve an IP address when connected to a network
with a DHCP server.
Important!
Both the Control and AES67 connections must be connected to 1000BASE-T (Gigabit) switch
ports. If a port will not be used, it should not be connected to a switch but does require a spe-
cific configuration described below. If both the Control and AES67 ports are used, each must
be on a different subnet.
To set a fixed IP address for the Control port:
• Press the Right button until the IP Configuration (Control) screen is displayed
• Press the OK button to highlight "Edit"
• Press OK again to highlight "Use DHCP"
• Press the Right button to highlight "Yes"
• Press the Up/Down button to "No"
• Press the Left button to highlight the "Use DHCP" field
• Press the Down button to highlight "Address"
• Press the Right button to move to the first digit of the IP address
• Use the Up/Down buttons to change the selection
• Press the Right/Left buttons to select another digit to edit
• When finished editing the address field, press the Right or Left button to return to "Address"
• Press the Down button to navigate to the Netmask and Gateway fields
• Repeat the above steps to edit the Netmask and Gateway fields; note that the gateway may be set
to 000.000.000.000 if no gateway is required
• After the gateway is set, press the Left button to highlight "Gateway"
• Press the Down button to highlight "Update"
• Press OK to save the new IP information
• Remove power from the ARC for at least 10 seconds, and then re-apply power.
• If you suddenly notice you've entered some incorrect information and need to start over, use the
Right/Left buttons to highlight "Cancel" followed by "OK"
If you are using AES67 I/O, use the Left/Right buttons to navigate to the IP Configuration (AES67) screen.
The steps for configuring this port are identical to those above for the Control port. Please remember that
when both the Control and AES67 ports are used, each must be on a different subnet.
Advertisement
Table of Contents
