Duplex Settings Editor (Dt602D); Emergency Stop - Digitrax Evolution Express Series Manual

7.3.6 Duplex settings Editor (DT602D)

If a DT602D is plugged into LocoNet, in the
Utility Task screen press the
Duplex-enabled throttles will show the Duplex
Edit screen, allowing Duplex setting modification.
1. Follow the prompt scroll to select and modify
the Duplex settings wanted.
2. When complete press the
write the new settings to the LocoNet system.
3. A Key value 0000 turns OFF the joining pass-
key# requirement.

8.0 Emergency Stop

To stop everything on a powered layout immediately:
Press the key then the
This option will stop everything on the layout, without knowing what locomo-
tive is on which throttle, or the need to actively control the speed of any loco-
motive.
Do not turn Track Power off during a short circuit. Clear the short first.
To Emergency Stop the active knob controlling a locomotive: Press and
hold down the
the throttle will beep. The release the
1/2 second to also emergency stop a locomotive controlled on the other DT602
knob.
Having Trouble Stopping? If the deceleration CV value you set for a partic-
ular loco is very large, this can make it look like the loco is not stopping on
command because the deceleration CV value is causing the loco to take a long
time to come to a stop. Emergency stop commands force an immediate stop
with no deceleration delays.
© 2020 Digitrax, Inc.
key. DT602D
"Update" key to
key to turn off track power to the whole layout.
key for about one second and the speed will go to zero and
Duplex Info Edit:
RF Net Name: Club_Net
Channel #:
Key#:
IR ID#:
key, or hold down for another about
25 25
15
4567
01
Update
www.digitrax.com