Removing A Locomotive From An Mu; Mu Of Mismatched Locomotives; Controlling Functions On Mu'ed Locomotives - Digitrax Evolution Express Series Manual

4.10 Removing a Locomotive from an MU

To remove a locomotive address from an MU:
1. Select the locomotive address you want to remove from a consist. To do
this, press
in the Loco Info Area will begin to blink black and gray, and the consist
flag "cn" should show in the Loco Info area indicating this address is in a
consist. The soft keys will also change to give you the options "MU",
"Recall" and "MORE"& press
2. Press the
sist the new soft key settings will include an "MU-" choice
3. Press the
the consist. The DT602 will exit MU mode and the removed locomotive
will now be selected on the throttle.

4.11 MU of mismatched locomotives

If all the locomotives in the MU have performance characteristics that are
closely matched, you can run all the MUed locomotives in e.g. 128 step mode.
If the units are completely mismatched (for example, if you are running two
different brands of locos with noticeably different characteristics), then we
recommend speed matching the locos by programming the decoder with either
Simple 3 step or Advanced 28 step loadable speed tables (See your Decoder
Manual for more information on these features of your decoder).

4.12 Controlling functions on MU'ed locomotives

Even though an individual locomotive is part of an MU and you can't control
its individual speed and direction, you can still control its function outputs
independently as follows:
1. Select the loco that is part of an MU which you wish to independently con-
trol functions. To do this, press
again to complete selection of the consisted loco.
2. Now use the numeric keypad to control the consisted loco's functions like
you would any other loco. The changes will take effect immediately if the
locomotives are moving, otherwise changes will take effect when you rese-
lect the TOP address on the throttle.
3. When you are finished turning functions on or off for the consisted loco,
simply select the TOP address and resume running the MU.
4. Remember, you will not be able change the speed or direction of any indi-
vidual loco that is part of an MU. Locomotive speed and direction for all
locos in the MU are controlled ONLY by the TOP address loco.
© 2020 Digitrax, Inc.
and enter the address numbers. The large address numbers
once to enter MU mode, If the flashing address is in a con-
key labeled "MU-": This removes the flashing address from
again.
enter the address numbers & press
14
14
www.digitrax.com