Pulley - BodyCraft MA605LP Instruction Manual

If previously installed, completely remove TOP CABLE(84), along with pulleys T1, T2,
T3, T4 and T5. Remove the two bolts and attach the TOP BEAM into the FRONT
UPRIGHT. Assemble TOP CABLE(84A) (from leg press box) and pulleys simultaneously.
Insert threaded end of TOP CABLE(84A) into slot in front of TOP BEAM, over pulleys
T1, T2, around pulley T3, and over T4. Run threaded end of TOP CABLE(84A) through
SINGLE PULLEY BRACKET(211) and attach pulley G1 as shown. Finish by routing TOP
CABLE(84A) over pulley T5 and attach threaded end of TOP CABLE(84A) into SELECTOR
ROD. For safety reasons, the threaded end should be screwed in using at least half of
the available screw length. The jam nut should be tightened to SELECTOR ROD to
prevent loosening. Replace the two bolts that attach the TOP BEAM to the FRONT
UPRIGHT and tighten. Make certain the TOP CABLE(84A) runs above these bolts.
Attach RUBBER BUMPER(215) to top of SINGLE PULLEY BRACKET(21).
TOP CABLE(84A)
84A
T2
T4
T5
T3
L5
G1
84A
211
234
LEG PRESS CABLE
LEG PRESS CABLE(234)
T5
80
9
51
65
FLOATING PULLEY BLOCK(32)
TOP
T1
CABLE(84A)
LOWER
CABLE(87)
T5
75
51
77
90
75
T3
L5
T3
L5
6
T2
T4
84A
T3
L5
P2
AB
CABLE(86)
A2
L7
LOWER
CABLE(87)
A2
L7
T1