Advertisement
Assembly is complete! Please take the following steps before using the gym:
1. Make certain all bolts are tightened securely.
2. Make certain all cables are seated into all pulley grooves. A cable rubbing
against steel will peel the nylon coating, voiding warranty and resulting in a
need for replacement.
3. Pre-stretch the cables. Put the Selector Pin (41) in the bottom hole on the
weight stack. Pull on the cables with great force, helping remove any kinks
and providing any initial cable stretch.
4. Be aware the cables can loosen and slightly stretch upon initial use.
5. The cables should be adjusted as tight as possible, but no so tight as to lift
the Top Plate (19) above the weight stack. Be certain to secure the jam nuts
after adjustments are made.
6. For better performance, apply a household lubricant (such as silicone) to any
adjustable areas and to the Guide Rods (5).
7. Enjoy many years of a Fit Lifestyle.
Thank you for purchasing the BODYCRAFT HFT Strength Training System!
If you have questions or comments, please contact your BodyCraft dealer
or contact BODYCRAFT directly at 800-990-5556 or info@bodycraft.com.
Please REGISTER your BODYCRAFT HFT at www.bodycraft.com
Advertisement
