VERITAS NetBackup 5330 Hardware Service Procedure page 10

9 Remove the battery by sliding it towards the rear of the canister.
10 Locate the replacement canister.
11 Insert the battery into the battery compartment in the replacement canister.
12 Slide the battery towards the front of the replacement canister under the tabs along the sides of
the compartment.
13 Move the blue locking handle up to secure the battery circuit board to the replacement canister.
To make sure that the battery is seated correctly, you might need to slide it out and insert it again.
14 Reinstall the cover on the replacement canister by sliding the cover forward until the latch buttons
click.
15 Remove the air blocker in the empty slot in the Primary storage shelf.
To install a replacement RAID or Expansion canister
1 Slide the new canister all the way into the rear panel of the chassis.
The following image shows the insertion of an Expansion canister. The mechanism for installing
a RAID canister is the same.
Installing a new Expansion canister
2 Rotate the levers towards the center of the canister to lock it into place.
3 Reinstall the FC SFPs into the RAID canister. This step does not apply to the Expansion canister.
HSP 133 RAID or Expansion canister replacement
10