Installation; Standard Installation - STIEBEL ELTRON DHB-E 13 LCD AU Operation And Installation

Electronically controlled comfort instantaneous water heater
Hide thumbs Also See for DHB-E 13 LCD AU:
Table of Contents

Advertisement

INSTALLATION

Installation
10. Installation
Factory settings
Internal anti-scalding protection in °C

Standard installation

Electrical connection from below on unfinished walls x
Water connection, installation on finished walls
For further installation options, see chapter "Alternative instal-
lation methods".
10.1 Standard installation
Opening the appliance
f Open the appliance by holding the fascia at the side and pull-
f
ing forwards away from the appliance cover. Undo the screw.
Pivot open the appliance cover.
f Remove the back panel by pressing the two locking tabs and
f
pulling the lower section of the back panel forwards.
Preparing the power cable on unfinished walls, for connection
from below
160
30
1 Cable entry installation aid
f Prepare the power cable.
f
Fitting the wall mounting bracket
www.stiebel-eltron.com
DHB-E 13 LCD AU
Tmax
DHB-E 13 LCD AU
x
f Mark out the holes for drilling using the installation tem-
f Drill the holes and secure the wall mounting bracket at 2
f Fit the wall mounting bracket.
Preparing the water connection
f Remove the caps from the tees.
f Fit the plugs and the extensions with gaskets.
1
1 Strainer
2 Plastic profile washer
f Fit the strainer and the plastic profile washer in the tee for
Removing the flow limiter
DHB-E 18 LCD AU
Tmax
DHB-E 18 LCD AU
x
x
f
plate. If the appliance is to be installed on finished walls, also
mark out the fixing hole in the lower section of the template.
f
points using suitable fixing materials (screws and rawl plugs
are not part of the standard delivery).
f
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f
f
1
2
f
the cold water inlet.
Damage to the appliance and environmental pollution
!
The strainer must be fitted for the appliance to function.
f When replacing the appliance, check that the strain-
f
er is present.
Note
If you are using a thermostatic valve, you must not re-
move the flow limiter.
DHB-E 27 LCD AU
Tmax
DHB-E 27 LCD AU
x
x
DHB-E LCD AU|
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dhb-e 18 lcd auDhb-e 27 lcd au

Table of Contents