Energy Saver Operation - Arctic King WWK Series User Manual

1
NOTES
• Button design is based on a typical model and may slightly vary from the actual one
you purchased.
• All the functions described can also be accomplished using the unit's control panel. If
the unit is without this feature, there will be no corresponding operation when pressing
the relevant button on the remote controller.
• When there are significant differences between features or operation implied by
the remote control illustration and the actual functions described in the USER'S
MANUAL, the descriptions in the USER'S MANUAL shall prevail.
• The device may comply with local national regulations. In Canada, it should comply
with CAN ICES-3(B)/NMB-3(B). In USA, this device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications not approved by the party responsible for compliance
could void users authority to operate the equipment.

ENERGY SAVER OPERATION

In this mode, the fan will continue to run for 3
minutes after the compressor shuts off. The fan
then cycles on for 2 minutes at 10 minute intervals
until the room temperature is above the set
temperature, at which time the compressor turns
back on and cooling resumes.
Page 27