Install Support Bracket - Arctic King WWK Series User Manual

Measure from the cabinet edge
INSIDE
OUTSIDE
Wooden Windows
Measure from the cabinet edge
INSIDE
OUTSIDE
Vinyl-Clad Windows

4. INSTALL SUPPORT BRACKET

Fig. 7A
Fig. 8A
Page 16
H: About " to
5/8 3/4
H: About to 1"
3/4"
Fig. 5
3. Extend the side panels out against the window
Fig. 6
frame (Fig. 6).
window
frame
Fig. 7B
B1: For wooden windows:
Drive 1/2" (12.7 mm) locking screws through the
frame lock and into the sill (Fig. 8A).
NOTE: To prevent window sill from splitting, drill 1/8"
(3mm) pilot holes before driving screws. Drive 1/2"
(12.7mm) locking screws through frame holes into
window sash (Fig. 8B).
2. While keeping a firm grip on the air
conditioner, carefully place the unit into
the window opening so the bottom of
"
the air conditioner frame is against the
window sill (Fig. 5). Carefully close the
window behind the top rail of the unit.
NOTE
Check that air conditioner is tilted
back per dimension H (Fig. 5) (tilted
about 3° to 4° downward to the
outside). After proper installation,
condensate should not drain from the
overflow drain hole during normal use.
Adjust the slope if otherwise.
A. Place the frame lock between the
frame extensions and the window
sill as shown (Fig. 7A for Wooden
windows), (Fig. 7B for Vinyl-Clad
windows).
Drive 3/4" (19 mm) or 1/2" (12.7 mm)
locking screws through the frame lock
and into the sill.