Unit Control Panel; Energy Saver Button - Arctic King MWDUL-10CRN1-BCJ4 Operator's Manual

NOTE: The following instructions refer to the unit controls the same instructions can be used for the
remote control.

Unit Control Panel

Enery Saver Mode
ON/OFF Button
The unit will intiate automatically the ENERGY SAVER function under COOL
(AUTO COOL and AUTO FAN only) modes.
UP/DOWN Button
Press or hold the left (<) or right (>) button until the desired temperature is displayed. This temperature
will be automatically maintained anywhere between 62°F (17°C) and 86°F (30°C). If you want the display
to read the actual room temperature, refer to the "Operating the Fan Only" section.
NOTE: This appliance provides a features that will allow you to set and display temperatures in Celsius or
Fahrenheit. To change the temperature display on the main unit, press the left (<) and right(>) button to
simultaneously for 3 seconds to alternate between the °C & °F scale.
FAN Button
This mode selects the fan speed in four steps: AUTO, LOW
shifts the fan speed mode. For some models, the fan speed cannot be adjusted under and HEAT mode.
On DRY mode, the fan speed is automatically at LOW.

Energy Saver Button

mode s. The fan
SLEEP Button
,
SLEEP
SLEEP button again.
Operating Instructions
Timer Activation
Mode
Selector
COOL, DRY
-
SLEEP
Temperature/ Time/
Error Code Display
, MED
, AUTO (only AUTO-COOLING and AUTO-
2ºF/1ºC
2ºF/1ºC
6
Remote Signal
Unit ON/OFF Receptor
, DRY , and AUTO
, or HIGH . Each button press
FAN)