Heat Operation/Cool Operation; Dry Operation; Auto Operation; Timer Operation - Arctic King WPPD08CW0N User Manual

Operating Instructions
HEAT operation (Only for heat & cool
models)
• Press the "MODE" button until the
"HEAT" indicator light comes on.
• Press the ADJUST buttons "+" or " - "
to select your desired room temperature.
The temperature can be set within a
range of 17°C~30°C/62°F~86°F(or 88°F).
• Press the "FAN SPEED" button to choose
the fan speed. For some models, the fan
speed can not be adjusted under HEAT
mode.
COOL operation
• Press the "MODE" button until the
"COOL" indicator light comes on.
• Press the ADJUST buttons "+" or "-"
to select your desired room temperature.
The temperature can be set within a
range of 17°C~30°C/62°F~86°F.
• Press the "FAN SPEED" button to
choose the fan speed.

DRY operation

• Press the "MODE" button until the
"DRY" indicator light comes on.
• While in this mode, you cannot select
a fan speed or adjust the temperature.
The fan motor operates at LOW speed.
• Keep windows and doors closed for the
best dehumidifying effect.
• Do not connect the duct to a window.

AUTO operation

• When you set the air conditioner to
AUTO mode, it will automatically select
cooling, heating (cooling only models
excluded), or fan only operation
depending on what temperature you
have selected and the current room
temperature.
• The air conditioner will control room
temperature automatically according
to the temperature point set by you.
• Under AUTO mode, you cannot select
the fan speed.
FAN operation
• Press the "MODE" button until the
"FAN" indicator light comes on.
• Press the "FAN SPEED" button to
choose the fan speed. The
temperature cannot be adjusted.
• Do not connect the duct to a window.

TIMER operation

• When the unit is on, pressing the Timer
button will initiate the Auto-off stop
program. The TIMER OFF indicator light
illuminates. Press the Up or Down button
to select the desired time. Press the TIMER
button again within 5 seconds. The Auto-
on start program is initiated and the TIMER
ON indicator light illuminates. Press the up
or down button to select the desired Auto-
on start time.
• When the unit is off, press the Timer button
to initiate the Auto-on start program.
Pressing it again within five seconds will
initiate the Auto-off stop program.
• Press or hold the Up or Down button
to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start.
• The system will automatically revert back to
display the previous temperature setting if
there is no operation within 5 seconds.
• Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop timer program.
• Should a malfunction occur, the Auto Start/
Stop timed program will be cancelled.
SLEEP/ECO operation
Pressing this button will increase
(during cooling operation) or decrease
(during heating operation, applicable
models) 1°C/1°F after 30 minutes. The
temperature will again increase (cooling)
or decrease (heating) by another 1°C/1°F
after an additional 30 minutes. This new
temperature will be maintained for 7 hours
before returning to the originally selected
temperature. This ends the Sleep/Eco
mode and the unit will continue to operate
as originally programmed.
NOTE
This feature is unavailable in FAN or
DRY mode.
Page 9