Portable Air Conditioner (Local Air Conditioner) Instruction Manual Model: WPPH-06CR5 WPPH-08CR5 WPPH-10CR5 Thank you for purchasing our Portable Air Conditioner. Before using your air conditioner, please read this instruction manual carefully and keep it for future reference. READ AND SAVE THESE INSTRUCTIONS!
Preparation control panel remote signal receptor horizontal louver control lever(adjust manually) NOTE: PHA can not be adjusted. vertical louver control lever(adjust manually) NOTE: PHA can not be adjusted. panel Caster front handle (both sides) air filter (behind the grille) upper air intake drain outlet air outlet lower air intake...
Safety Precautions Please read through these instructions before you start the installation process. Improper installation can cause damage to the unit, your personal property, and also poses a personal safety hazard. -Installation must be performed according to the installation instructions. Improper installation can cause water leakage, electrical shock, or ﬁre.
Cautions -This appliance can be used by children aged from 8 years and above and person with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Installation Choosing The Right Location Your installation location should meet the following requirements: -Make sure that you install your unit on an even surface to minimize noise and vibration. -The unit must be installed near a grounded plug, and the Collection Tray Drain (found on the back of the unit) must be accessible.
Installation Tools Needed -Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors; -Saw (optional, to shorten window adaptor for narrow windows) Accessories Your Window Installation Kit ﬁts windows 67.5-123cm(26.5-48”) and can be shortened for smaller windows. Part Description Quantity 1 pc Unit Adaptor 1 pc...
Installation Note: Once the Exhaust Hose assembly and Adjustable Window Sliderare prepared, choose from one of the following two installation methods. Type 1: Hung Window Installation Foam seal B Foam seal C (Adhesive type-shorter) (Non-adhesive type) Window slider B Window slider A (if required) Foam seal A (Adhesive type)
Installation Security Bracket 2 Screws Insert the window slider adaptor If desired, install the security into the hole of the window slider. bracket with 2 screws as shown. Note: To ensure proper function, DO NOT overextend or bend the hose. Make sure that there is no obstacle around the air outlet of the exhaust hose (in the range of 500mm) in order to the exhaust system works properly.
Operation MODE button Timer mode indicator Selects the appropriate operating light (set only by remote controller) mode. Each time you press the Power indicator light button, a mode is selected in a sequence that goes from COOL, LED display FAN and DRY .The mode indicator Shows the set temperature while on cool light illuminates under the different mode.
Operation Operation Instructions COOL operation -Press the "MODE" button until the "COOL" indicator light comes on. -Press the ADJUST buttons "+" or "-" to select your desired room temperature. The temperature can be set within a range of 17°C~30°C/62°F~86°F. -Press the "FAN SPEED" button to choose the fanspeed. DRY operation -Press the "MODE"...
Operation AUTO-RESTART If the unit breaks off unexpectedly due to the power cut,it will restart with the previous function setting automatically when the power resumes. WAIT 3 MINUTES BEFORE RESUMING OPERATION After the unit has stopped, it can not be restarted operation in the first 3 minutes. This is to protect the unit.
Maintenance Safety Precautions -Always unplug the unit before cleaning or servicing. -DO NOT use ﬂammable liquids or chemicals to clean the unit. -DO NOT wash the unit under running water. Doing so causes electrical danger. -DO NOT operate the machine if the power supply was damaged during cleaning. A damaged power cord must be replaced with a new cord from the manufacturer.
Faults Diagnosis Please check the machine according to the following form before asking for maintenance: Problem Troubleshooting Possible Cause The Water Collection Tray is full.Turn off the unit, drain the water from the P1 Error Code Water Collection Tray and restart the Unit does not turnon unit.
Design and Compliance Notes Design Notice In order to ensure the optimal performance of our products, the design speciﬁcations of the unit and remote control are subject to change without prior notice. Energy Rating Information The Energy Rating for this unit is based on an installation using an un-extended exhaust duct without adapters A or B (as shown in the Installation section of this manual).
Sociable Remark When using this dehumidifier in the European countries, the following information must be followed: DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separatelyfor special treatment is necessary.It is prohibited to dispose of this appliance in domestic household waste.For disposal, there are several possibilities:A) The municipality has established collection systems, where electronic waste can be disposed of at least free of charge to the user.B)