If Ac Is Blocked By Storm Window; Removing Ac From Window - Arctic King WWK Series User Manual

Fig. 8B
Temp Timer
Auto Auto
Low Cool
Med Dry
High Fan
Fan Mode
On Off
Energy Timer Sleep
Saver
ON Off
Check
Filter
Fig. 9
FOAM SEAL
Fig. 10

If AC is Blocked by Storm Window

Storm window
1-1/2"min
frame or other
(38 mm)
obstruction.

Removing AC From Window

• Turn AC off, and disconnect power cord.
• Remove sash seal from between windows, and unscrew safety lock.
• Remove screws installed through frame and frame lock.
• Close (slide) side panels into frame.
• Keeping a firm grip on air conditioner, raise sash and carefully remove.
• Be careful not to spill any standing water while lifting unit form window. Store parts
WITH air conditioner.
B2: For Vinyl-Clad windows:
Drive 1/2" (12.7 mm) locking screws through the frame
lock and into the window sash (Fig. 8B).
NOTE: Before driving the screws, use a drill to drill 5
holes through the holes in the frame lock and frame
extensions into the windows sash as shown (Fig. 8B).
C. To secure lower sash in place, attach right angle sash
lock with 3/4" (19 mm) or 1/2" (12.7 mm) screw as
shown (Fig. 9).
D. Cut Window sash seal foam and insert it in the space
between the upper and lower sashes (Fig. 10).
Fig. 11
SASH
Board thickness
as required, for
proper pitch to rear,
along entire
sill. Fasten with nails
or screws.
Add wood as shown in Fig. 11, or remove
storm window before air conditioner is
installed.
If storm window frame must remain,
be sure the drain holes or slots are not
caulked or painted shut. Accumulated
rain water or condensation must be
allowed to drain out.
Page 17