Updating Of The Firmware - Pioneer RMX-1000 Service Manual

1

8.2 UPDATING OF THE FIRMWARE

A
[On the Updater File]
Filename: rmx****.upd
The following 4 types of firmware are included in the updater file:
• MAIN UCOM (SH UCOM)
• SUB UCOM (K0R UCOM)
• DSP (program)
• DSP (data)
[Procedures]
1 Copy the updater file into the root directory of the SD card.
B
Note: SHXC cards are not supported.
2 Turn the unit ON by holding the TAP and HOLD buttons pressed.
(Hold the two buttons pressed until the 7-segment indicator lights.)
3 Load the SD card.
(As soon as the SD card is loaded and Firmware Update mode is entered, updating will start.)
4 Updating will proceed.
The progress of updating is indicated on the OUTPUT level indicator, as shown below.
C
Updating process
Standby for updating
SD card detected
Updater file detected
Updater file being read
Unmounting of the SD card completed
Updater file being verified
Start of writing to ROM and verification, 0%–20% of process finished
Writing to ROM and verification, 20%–40% of process finished
Writing to ROM and verification, 40%–60% of process finished
D
Writing to ROM and verification, 60%–80% of process finished
Writing to ROM and verification, 80%–100% of process finished
Writing to ROM and verification completed, 100% of process finished
5 After updating is completed, the results of updating are indicated with the 7-segment and OUTPUT level indicators,
as shown below. Turn the unit off then back on again.
Updating process
Updating error of SH/DSP
Updating error of K0R
E
K0R communication error
UPD file not detected
UPD file damaged or improper
SD communication error or not supported
SD connection error (SD card unloaded during updating process)
FLASH ROM erasure error
FLASH ROM writing error
FLASH ROM verification error
Updating properly completed
F
66
1
2
7-segment indication
[___] (Version No.)
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
[Upd]
7-segment indication
[E00]
[E10]
[E20]
[E30]
[E40]
[E50]
[E60]
[E70]
[E80]
[E90]
[___] (Version No.) All lit
RMX-1000
2
3
Lighting/flashing state of the LEDs
of the OUTPUT level indicator
OVER flashing
-15dB flashing
-9dB flashing, -15dB lit
-6dB flashing, -15dB to -9dB lit
-3dB flashing, -15dB to -6dB lit
-1dB flashing, -15dB to -3dB lit
0dB flashing, -15dB to -1dB lit
1dB flashing, -15dB to 0dB lit
3dB flashing, -15dB to 1dB lit
5dB flashing, -15dB to 3dB lit
9dB flashing, -15dB to 5dB lit
OVER flashing, -15dB to 9dB lit
Lighting/flashing state of the LEDs
of the OUTPUT level indicator
-15dB flashing, OVER lit
-9dB flashing, OVER lit
-6dB flashing, OVER lit
-3dB flashing, OVER lit
-1dB flashing, OVER lit
0dB flashing, OVER lit
1dB flashing, OVER lit
3dB flashing, OVER lit
5dB flashing, OVER lit
9dB flashing, OVER lit
3
4
4