Pioneer RMX-1000 Service Manual page 45

5
3. Description of Test Mode
1 Mode 1: "VER" for confirmation of the versions
• This mode is for confirming the versions of the system, MAIN UCOM (SH UCOM), SUB UCOM (K0R UCOM),
DSP [program], and DSP [data].
After entering this mode, "VEr" is displayed on the 7-segment indicator for about 1 sec then version display starts.
• Five modes for displaying the versions of the system, MAIN UCOM (SH UCOM), SUB UCOM (K0R UCOM), DSP [program],
and DSP [data] are provided with this mode. These five modes can be switched, using the NUDGE + or – button.
When these modes are switched, the name of the software is displayed for about 1 sec then its version is displayed.
When Mode 1 is entered, the System Version Display mode is automatically entered.
To change the
software to be displayed
2 Mode 2: "CLR" for making all LEDs and the 7-segment indicator unlit
• This mode is for making all LEDs and the 7-segment indicator unlit.
Only after this mode is entered, "CLr" is displayed for 1 second on the 7-segment indicator.
Note: The FX SOURCE INPUT, FX SOURCE X-PAD, QUANTIZE, X-PAD, AUTO, and HOLD buttons are lit dimly.
3 Mode 3: "SET" for making all LEDs and the 7-segment indicator lit
• This mode is for making all LEDs and the 7-segment indicator lit.
Only after this mode is entered, "Set" is displayed for 1 second on the 7-segment indicator.
• While holding the AUTO button pressed, you can adjust the luminance of the SCENE FX indicator by turning the
ISOLATE FX LOW or MID control.
Control
ISOLATE FX LOW knob
ISOLATE FX MID knob
5
6
Display of the name of
software and version
LED to be lit
SCENE FX indicator (red)
SCENE FX indicator (blue)
RMX-1000
6
7
Name of
software
System
MAIN UCOM (SH UCOM)
SUB UCOM (K0R UCOM)
DSP (program)
DSP (data)
Remarks
"MIN": To be unlit
"MAX": Maximum luminance
"MIN": To be unlit
"MAX": Maximum luminance
7
8
A
B
7-segment
indication
SYS
MAi
SUb
d_P
d_d
C
D
E
F
45
8