Table of Contents
Advertisement
VersaLink Wireless Gateway (Model 7500)
Authentication Method
WPA Type
WPA2 Pre-
Authentication
Group Key Update
Interval (in seconds)
WPA Shared Key
After you have entered your values and clicked Apply in the WPA screen, the following pop-up screen will appear.
The pop-up screen indicates that wireless access may be interrupted. Click OK to continue.
NOTE: Wireless access to the Router may be interrupted and wireless stations may require reconfiguration.
030-300536 Rev. A
Factory Default = Personal (Pre-Shared Key)
Personal (Pre-Shared Key) – WPA stations share a pre-shared key (string format) with the
Router and do not authenticate with the RADIUS server.
Enterprise 802.1x – WPA stations authenticate with the RADIUS server using EAP-TLS over
802.1x, a standard for passing extensible authentication protocol (EAP) for authentication
purposes. EAP is used to communicate authentication information between the supplicant and
the authentication server. With 802.1x EAP messages are packaged in Ethernet frames, rather
than using and PPP.
Factory Default = WPA Any
WPA Any – Allows stations that support WPA, WPA2, or WPA Any to connect to the Router.
WPA – Allows stations that support WPA v.1 to connect to the Router.
WPA2 – Allows stations that support WPA v.2 to connect to the Router.
Factory Default = Disabled
To Enable this feature, click the box (a check mark will appear in the box).
The number of seconds between rekeying the wPA group key. A value of zero means that
rekeying is disabled.
The WPA key can be either 8 to 63 text (ASCII) characters or 64 hexadecimal (Hex) characters.
The only allowable hexadecimal characters are: A-F and 0-9.
WPA
62
User Guide
August 2007
Advertisement
Table of Contents
