Table of Contents
Advertisement
VersaLink Wireless Gateway (Model 7500)
16.18 Private LAN—Configuring NAT
In the Advanced screen, click Private LAN. The following screen will appear. Private LAN allows you to set up a
network behind your Router.
If you change the settings in this screen, click Apply. If you click Reset, the screen will refresh and the previously
saved settings will remain active.
IMPORTANT: Whenever you change the settings in a screen, the screen will display the changes; however, you must
click Apply to allow the changes to take effect in the Router. (Private LAN is the default setting for VersaLink.)
Private LAN DHCP Server Enable
Private LAN Enable
Modem IP Address
Subnet Mask
DHCP Start Address
DHCP End Address
DHCP Lease Time
Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.
030-300536 Rev. A
Private LAN
Default = Enabled
If this box contains a check mark, this enables DHCP addresses to be
served from the Private LAN pool.
Default = Enabled
If this box contains a check mark, this enables the addresses from the
Private LAN to use the NAT interface.
Displays the Router's IP address.
Displays the Subnet Mask, which determines what portion of an IP
address is controlled by the network and which portion is controlled by the
host.
Displays the first IP address that the DHCP server will provide.
Displays the last IP address that the DHCP server will provide.
Displays the amount of time the provided addresses will be valid, after
which the DHCP client will usually resubmit a request.
160
User Guide
August 2007
Advertisement
Table of Contents
