Table of Contents
Advertisement
VersaLink Wireless Gateway (Model 7500)
5.2 Cable Connectors and Switch Locations
•
DSL connector (RJ-11)
•
Reset push button
•
Four Ethernet (RJ-45) connectors with optional UPLINK/E1 port and optional E4/DATA port
NOTE:
1. When using the optional UPLINK/E1 jack (when VersaLink is configured for WAN Uplink mode),
Ethernet LAN connection is limited to ports E2, E3, and E4. The Uplink feature is optional. If Uplink is not
enabled via the Web pages, VersaLink will use DSL as the WAN interface.
2. If you desire to install VersaLink via USB, use the optional E4/DATA port, which can be used for either
USB or Ethernet installation. See section 6 for hardware installation instructions.
•
Power connector (12 VDC) barrel
•
OFF/ON power switch
DSL Line
Connector
5.3 Connector Descriptions
The following chart displays the Router's connector types.
N
AME
DSL LINE
UPLINK/E1
E2/E3/E3
E4/DATA
030-300536 Rev. A
VersaLink Gateway - Rear View
Reset
Ethernet Connectors
(UPLINK/E1 E2, E3, E4/DATA)
Button
T
YPE
Modular 6-pin (RJ-11) DSL
jack
Modular 8-pin (RJ-45)
Ethernet jack
Modular 8-pin (RJ-45)
Ethernet jack
Modular 8-pin (RJ-45)
Ethernet jack
Power
Connector
Connects the Router to a telephone jack that has
active ADSL service or to the DSL port of a POTS
splitter.
Connects the Router to a PC or Hub via 10/100
BaseT Ethernet.
Connects the Router to a PC or Hub via 10/100
BaseT Ethernet.
Connects the Y-cable provided with the kit to the
10/100 Base-T Ethernet
of the Router and to the Ethernet port on a PC or
Hub. The USB connector
also functions through the Router's E4/DATA port.
When the Ethernet connector is plugged in to the
Router's DATA port, the USB cable can then be
plugged in to the USB port on a PC or Hub. Thus,
the Y-cable provides Internet connectivity via
Ethernet or USB; however, both connectors cannot
be used sumultaneously. If both connectors are
10
User Guide
Off/On
Power Switch
F
UNCTION
DATA port on the rear
built in to the Y-cable
August 2007
Advertisement
Table of Contents
