Table of Contents
Advertisement
VersaLink Wireless Gateway (Model 7500)
If you clicked the Public LAN Enable box, the following screen will appear. After you have made changes to this
screen, click Apply to allow the settings to take effect.
If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warning
messages may be appear in pop-up screens. If this occurs, check the Public LAN Configuration settings.
Warning Message
Start Address is not part of the Subnet
End Address is not part of the Subnet
End Address is below the Start Address
Lease time must be greater than 10 seconds
Seconds must be between 0 and 59
Minutes must be between 0 and 59
Hours must be between 0 and 23
Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.
If you clicked Apply in the Public LAN screen, a warning screen will display the following message:
Warning: Enabling Public LAN will disable Private LAN.
Your Modem will reboot automatically due to IP address modifications.
After the reboot, you may need to release and renew your IP address to communicate with the modem.
Click OK to allow the modem to reboot. After the modem has rebooted, confirm that you have a DSL link and that
your PPP Status displays UP.
030-300536 Rev. A
Check Public LAN DHCP Settings
Check the value in the DHCP Start Address field
Check the value in the DHCP End Address field
Check the value in the DHCP End Address field
Check the values in the DHCP Lease Time fields
Check the Seconds field at DHCP Lease Time
Check the Minutes field at DHCP Lease Time
Check the Hours field at DHCP Lease Time
163
User Guide
August 2007
Advertisement
Table of Contents
