Table of Contents
Advertisement
PROGRAMMING
SAMPLE PROGRAM FOR THE PENDULUM
1. Assemble the model using the instructions on the previous pages. Put the
model on the floor in an open area. Hold it upright and turn it on.
2. Establish the Bluetooth connection with the app. Open the Pendulum program.
Note that the balance setting is set to D.
3. Press the run button. Hold the model until it is standing upright and balancing
on its own. Observe the pendulum's behavior as the robot runs the program.
Below, write down what the robot does for each command step of the program.
Balance
Setting:
D
WHAT'S HAPPENING?
Record your observations here.
Programming the Turtle Robot
Programming the Pendulum
29
29
Advertisement
Table of Contents
