Table of Contents
Advertisement
PROGRAMMING MODE
Writing a Program
To create a command step, press
the circular plus sign button (A).
The command step settings
window will appear.
There are three tabs on the command step settings
window: motion (B), lights (C), and sounds (D).
On the motion tab, use the sliders to set the values
for the motor power (E) and duration (F). Use the
buttons to set the turning angle (G).
On the lights tab, select the color of the light (H)
you want to light up inside the robotic base unit
during the duration of this command step.
On the sounds tab, select the icon symbolizing the
sound effect (I) you want to play during the
duration of this command step.
Tap the check mark icon (J) to save your command
step into the program.
Tap the trash can icon (K) to delete a command step.
To save a program, press the save button (down
arrow icon, L).
To reset a program to its original state, press the
reset button (rotating arrows icon, M). The reset
button will reset a preset program to its original
command steps. For a user-defined program, the
reset button will clear all the command steps,
resetting it back to its original blank state.
Running a Program
When you are ready to run a program, press the run
button (triangle icon, N).
As the program runs, the highlighted command step
(O) shows the part of the program that is actively
being performed by the robot.
If you want to stop the program at any time, tap the
stop button (P).
14
A
B
C
D
E
G
F
H
I
J
M
O
K
N
L
P
Advertisement
Table of Contents
