Table of Contents
Advertisement
PROGRAMMING
SAMPLE PROGRAM FOR THE HOVERBOT IN ROVER MODE
1. After you have built the model using the assembly steps on the previous pages, keep the model in rover mode to
run the first sample program. Put the model on the floor in an open area and turn it on. Establish the Bluetooth
connection with the app.
2. Open the HoverBot Rover program. Note that the balance setting is set to C.
3. Press the run button. Observe the robot's actions as it runs the program. Below, write down what the robot does
for each command step of the program.
Balance
Setting:
C
WHAT'S HAPPENING?
22
Record your observations here.
Advertisement
Table of Contents
