6. Put a clearance gauge between the ignition module
and the flywheel. Tighten the screw to the correct
Servicing data on page 9 .
torque. Refer to
7. Assemble the remaining parts in the opposite
sequence to how they were disassembled. Refer to
To disassemble the ignition system on page 34 .
8.11 Flywheel
8.11.1 To disassemble the flywheel
1. Remove the cylinder cover.
2. Remove the starter unit and cooling air conductor.
To disassemble the starter on page 29 .
Refer to
3. Clean around the spark plug. Remove the spark
plug and put a piston stop in the spark plug hole.
4. Loosen but do not remove the screws that hold the
ignition module.
722 - 003 - 26.03.2019
5. Remove the flywheel nut (A). Remove the screws
(B), pawls (C), springs (D) and washers (E).
A
B
C
D
E
6. Use the flywheel puller kit to disassemble and
assemble the flywheel. Refer to
page 12 . Put the tool (F) supplied with the flywheel
puller kit in the center of the flywheel and attach the
screws (G) in the holes for the start hooks. Attach
the screw press (H) on the crankshaft.
H
G
Servicing tools on
F
Repair instructions - 35