Dismantling The Ignition Module And Flywheel - Husqvarna T540 XP Workshop Manual

7.7 Dismantling the ignition module
and flywheel
1
Dismantle the following:
• Starter and air guide rail.
• Clutch cover.
• Guide bar and saw chain.
• Front hand guard.
• Air filter cover and air filter.
• Centrifugal clutch and oil pump cover.
2
Loosen the vibration elements as outlined in figure 11
3
Unhook the spark plug cap and carefully lift the tank
unit to create enough space to get the ignition cable
and spark plug cap through. See Figure 12.
4
Grip the spring with a pliers and pull the ignition
cable out through the spark plug cap. see Figure 13.
Pour a little soap and water in the spark plug cap
to facilitate this step.
5
Loosen the handle half and remove the throttle
and the throttle lockout. Split the contact strips as
outlined in Figure 14.
6
Loosen the screws as outlined in Figure 15a and
remove the ignition module.
Fig 11
Fig 12
Fig 13
Fig 14
Fig 15a
Repair instructions
33
English –