Dismantling The Ignition Module And Flywheel - Husqvarna T525 Workshop Manual

Repair instructions
7.7 Dismantling the ignition module
and flywheel
1
Dismantle the following:
• Remove the cylinder cover.
• Detach the spark plug cable.
• Remove spark plug
• Remove the starter and air guide rail.
• Remove the flywheel cover
2
Remove the spark plug cap and spark plug. See
Figure 11 .
3
Grip the spring with a pliers and pull the ignition
cable out through the spark plug cap. see Figure 12.
Pour a little soap and water in the spark plug cap to
facilitate this step..
4
Detach the cables on the ignition module. See
Figure 13.
5
Remove the ignition module. See Figure 14.
26
– English
Fig 11
Fig 12
Fig 13
Fig 14