Husqvarna 545 Mark II Workshop Manual page 62

19. For 545G Mark II and 550 XP
the generator. Refer to
generator on page 54 .
20. Remove the cylinder and the piston. Refer to
disassemble the cylinder and piston on page 57 .
Note: Make sure that no dirt or object can come into
the bearings.
8.19.2 To disassemble the crankshaft and
crankcase
1. Remove the 3 screws (A) and remove the carburetor
bottom plate.
2. Remove the oil cap assembly (B).
3. Remove the 6 screws (C).
4. Remove the distance limiter (D).
D
62 - Repair instructions
®
G Mark II: Remove
To disassemble the
To
B
5. Remove the crankcase on the flywheel side from the
crankshaft. Use the crankcase splitting tool, refer to
Servicing tools on page 12 .
6. Remove the crankcase half on the clutch side from
the crankshaft. Use the crankcase splitting tool, refer
Servicing tools on page 12 .
to
A
7. If the main bearing is attached to the crankshaft, use
a puller tool to remove the main bearing.
C
722 - 003 - 26.03.2019