Dismantling The Ignition Module And Flywheel - Husqvarna 543 XP Workshop Manual

Repair Instructions
7.8 Dismantling the ignition module
and flywheel
1
Remove the cylinder cover. Remove the starter.
Snap off the ignition cable from the air guide plate
and remove the air guide plate. See figure 9.
2
Knock out a few of the pins in the tool if it does not
match up with the flywheel.
Use the tool to hold the flywheel in place while the
flywheel nut is loosened using a suitable socket
wrench. See figure 10.
3
use special tool 510 13 89-01 to remove the fly-
wheel. See figure 11.
4
Detach the ignition cable and loosen the screws.
See figure 12.
Cleaning and inspection
• Clean all parts, especially the tapers on the
flywheel and shafts.
• Check the flywheel for cracks or any other signs
of damage.
28
- English
Fig 9
Fig 10
Fig 11
Fig 12