Husqvarna 545 Mark II Workshop Manual page 34

8.10.5 To disassemble the ignition system
1. Remove the cylinder cover.
2. Remove the starter unit.
3. Remove the spark plug cable from the spark plug.
Remove the spark plug.
4. Remove the air filter, the air filter holder and the
To disassemble the carburetor
carburetor. Refer to
on page 46 .
5. Remove the screw (A) and the air nozzle (B).
B
A
6. Pull out the spark plug cable.
7. Remove the screws (C).
C
34 - Repair instructions
8. Disassemble the cable holder from the crankcase
and remove the cables and the ignition module.
9. Remove the cables from the cable holder, if it is
necessary.
8.10.6 To assemble the ignition system
1. Assemble the cables in the cable holder, if it is
necessary.
2. Attach the cable holder to the crankcase.
3. Attach the ignition module to the crankcase. Do not
tighten the screws (C) fully.
C
4. Put the spark plug cable through the crankcase.
Make sure that the spark plug cable is in the correct
position on the crankcase.
5. Attach the air nozzle.
722 - 003 - 26.03.2019