Emergency Shutdown Procedure - Husqvarna CT 36 Series Operator's Manual

Walk-Behind Trowels
Continued from the previous page.
Stopping the 9. Move the throttle to the idle position (a1).
machine
10.Push the stop button (b).
11.Turn the ON/OFF switch to the OFF position (c2).
12.Close the fuel valve by moving the lever to the left (k2).
13.Allow the machine to cool.
14.Clean the trowel after each use by flushing with water to remove concrete
splatter. Do not use a high pressure washer to clean electrical equipment.
Note: Do not attempt to clean, service or perform adjustments on the trowel while it
is running.
WARNING
Personal injury hazard. Touching a hot motor could burn the operator.
► Allow the motor to cool before cleaning or servicing the machine.
4.13

Emergency Shutdown Procedure

Procedure If a breakdown or accident occurs while the machine is operating, follow the
procedure below:
1. Stop the engine.
2. Close the fuel valve.
3. Remove the machine from the job site using correct lifting techniques.
4. Clean concrete from the blades and the machine.
5. Contact the rental yard or machine owner for further instructions.
wc_tx004127gb_FM10.fm
41
Operation