Emergency Shutdown Procedure - Husqvarna CRT48-33K Operator's Manual

CRT 48-33K
Continued from the previous page.
5. Install a full LP cylinder on the tank mount and fasten the clamps.
6. Connect the female hose coupling to the discharge valve on the full LP cylinder.
7. Apply leak test solution to the hose connection.
8. Slowly rotate the knob on the discharge valve counterclockwise until the valve is
fully open.
9. Watch and listen carefully for indications of leaking LP. If there are no leaks,
start the engine and run it for a few minutes to make sure that LP is flowing
smoothly.
The LP cylinder has now been replaced and the machine is ready for use.
4.20

Emergency Shutdown Procedure

Procedure If a breakdown or accident occurs while the machine is operating, follow the
procedure below:
1. Stop the engine.
2. Close the fuel valve.
3. Remove the machine from the job site.
4. Clean concrete from the blades and the machine.
5. Contact the rental yard or machine owner for further instructions.
wc_tx002045gb.fm
49
Operation