General Maintenance; Maintaining The Emission Control System; Periodic Maintenance Schedule - Husqvarna CT 36 Series Operator's Manual

General Maintenance

5 General Maintenance
WARNING
A poorly maintained machine can malfunction, causing injuries or permanent
damage to the machine.
► Keep the machine in safe operating condition by performing periodic
maintenance and making repairs as needed.
5.1

Maintaining the Emission Control System

Normal maintenance, replacement or repair of emission control devices and
systems may be performed by any repair establishment or individual; however,
warranty repairs must be performed by a dealer/service center authorized by the
engine manufacturer. See the supplied engine owner's manual for the applicable
emission warranty information.
5.2

Periodic Maintenance Schedule

The table below lists basic machine maintenance. Tasks designated with check
marks
points  require special training and equipment.
Check external hardware.
Clean trowel after each use to
remove concrete splatter.
Grease blade arms as needed.
Check drive belt.

may be performed by the operator. Tasks designated with square bullet
Walk-Behind Trowels
Every
Daily 50
hr



42
Every
100
hr

wc_tx004128gb_FM10.fm