Walk-Behind Trowels
Continued from the previous page.
2. Secure the blades to the trowel arms with screws (b).
Note: Dip the threads of the screws in grease prior to installation. This will prevent
concrete from cementing the screws in place and will make removal of the blades
easier.
3. Plug the remaining threaded holes in the blade brace with plastic plugs (c) to
prevent them from filling with concrete.
Result
The blades are now installed.
4.5
Installing and Adjusting the Handle
Assembling
On some machines, the handle comes folded and must be unfolded before
the handle
installation.
1. Straighten the handle and tighten the knob (a) to secure the handle in position.
2. Assemble the components to the handle, as shown.
c
3. Apply threadlocker to the lower block mounting screws (b).
4. Install the two lower block mounting screws and tighten them to 24 Nm
(18 ft. lbs.)
5. Assemble the throttle (c), as shown.
6. Apply threadlocker to the two throttle mounting screws.
This procedure continues on the next page.
wc_tx004127gb_FM10.fm
d
a
wc_gr014680
b
31
Operation
wc_gr014679