Husqvarna CT 36 Series Operator's Manual page 32

Walk-Behind Trowels
Continued from the previous page.
9. Attach the cable nut to the pitch control cable and adjust the cable nut so the
pitch control cable is snug but the trowel blades lay flat (0° pitch).
Installing the 1. Move the throttle to the idle position as shown.
throttle cable
2. Feed the throttle cable through the clamp (o) on the engine's recoil cover (p).
3. Connect the throttle cable to the engine throttle bracket by placing the special
bend through the hole in the throttle plate (q).
Note: If necessary for easier access, remove the air cleaner assembly.
4. Hold the engine throttle lever in the idle position and clamp the cable into the
throttle casing bracket (r).
5. Install the air cleaner assembly if it was removed.
This procedure continues on the next page.
wc_tx004127gb_FM10.fm
wc_gr014678
wc_gr014682
r
q
wc_gr014683
o
p
33
Operation