Operation; Camera Power; Ir Camera And Thermometer - FLIR TG267 User Manual

5

Operation

5.1 Camera Power

Power is supplied by a rechargeable lithium battery. Long press the power
button (center) to switch the camera ON or OFF. If the camera does not power
ON, charge the battery by connecting to an AC wall charger using the sup-
plied USB-C cable. The USB-C jack is located in the top compartment. Do not
use the camera while it is charging. When the top flap is closed, the camera is
rated IP54 for encapsulation. See Section 9.2, Battery Considerations and
Service, for more information.
The camera has an Auto Power OFF (APO) utility that switches it OFF auto-
matically if no buttons are pressed for the duration of the selected APO time.
Use the menu system (under Device Settings) To set the APO timer. See Sec-
tion 6, Programming Menu System, for more information.

5.2 IR Camera and Thermometer

Figure 5.1 Combined Thermal and Visible Image (MSX®)
1. Long press the power button to switch the camera ON.
2. If not already selected, choose the Thermal plus Visible Image mode in
the menu system (under Image Adjustments/Image Mode). You can adjust
the MSX® (Multi-Spectral Dynamic Imaging) alignment in the Image
Mode menu (press MENU at the MSX® image option and use the arrows
to make the adjustments; press MENU to confirm). Note that you can also
adjust the alignment directly in the normal operating mode using the arrow
buttons while viewing a Thermal Plus Visible image.
3. Point the camera toward the test area and scan as desired. View the cam-
era image on the display.
#NAS100014; r. AJ/68076/68076; en-US
7