Nexcom NDiS S538 User Manual page 49

Chapter 4: BIOS Setup
SATA Configuration
This section is used to configure the SATA device option settings.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Main Advanced Boot Security
SATA Configuration
SATA Mode Selection [AHCI]
SATA Test Mode [Disabled]
Serial ATA Port 0 TS256GMTS950T (256.0GB)
Software Preserve SUPPORTED
Port 0 [Enabled]
Hot Plug [Disabled]
Version 2.18.1263. Copyright (C) 2019 American Megatrends, Inc.
SATA Mode Selection
Configures the SATA as AHCI mode.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
SATA Test Mode
Enables or disables SATA test mode.
Copyright © 2019 NEXCOM International Co., Ltd. All Rights Reserved.
Save & Exit
Determines how SATA
controller(s) operate.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Port 0
Enables or disables SATA port 0.
Hot Plug
Enables or disables hot plugging feature on SATA port 0.
35
NDiS S538 User Manual