2Nd Level Programming - BFT CSB Xtreme (1.2) Installation And Operation Manual

EN
Connect the N.O. contact of the detector or photocell to the Close contact terminals.
If the vehicle is on the detector or in front of the photocell it does not cause immediate closing but rather you have to wait for the
signal to be released.

- : The close command acts as a release closing and safety function.
When closing, the close command engaging stops the automation. When disengaged the barrier resumes closing.

· :Default
- To reset the default parameters, set parameter  on 1 and exit the menu' .

· :Automation status display
- During operation, the control unit displays automation status so the installer is able to follow the logical fl ow of the board.
The status are:
: Idle
:
Opening
:
Stop opening limit switch
:
Stop opening
:
Closing
:
Stop closing limit switch
:
Stop closing
: N/A
The following table gives the 2nd level functions and the single settable parameters.
= DEFAULT value set in factory.
Par Function

Maximum operating time (sec.)

Request for maintenance
Programming maintenance

cycles in thousands
Programming maintenance

cycles in millions


Output 2, Output 3,

Output 4, Output 5


Termon
Control unit
8.3 LEVEL PROGRAMMING
2ND
-
: disabled
: active on the confi gured outputs
: active on the confi gured outputs and the bar lights fl ash twice

..
: request for maintenance
: photocell triggering
: encoder triggering
: PDM contact actuated
: arm closed
: arm open
: stop contact actuated
: warning fl ash
: Arm locking device
: open triggering
: contatto close attivato
: start triggering
: FRAC triggering
: UPS triggering
: second radio channel triggering (only OUT 5)
: Disabled
: Enabled and always active
: Enabled when needed by means of NTC sensor connected between
8k2 and COM input terminal
- 24 -
:
Stop due to photocell triggering
:
Opening due to photocell triggering
:
Photocell triggering pause
:
Stop due to encoder triggering
:
Opening due to encoder triggering
:
Pause due to encoder triggering
:
Maximum working time in opening reached
:
Maximum working time in closing reached
= parameter value set during installation: must be indica-
ted if DEFAULT value is modifi ed.
Settable data



.
