Table of Contents
Advertisement
Section 2
Figure 4
Wall Mounted Monitor's Depth
2.3 Panel Mounting the 8450
2.3.1 Panel Mounting Considerations
2.3.2 Panel Mounting Sequence
Page 12
Panel Mounting the 8450
To install the panel-mount enclosure, remove the monitor's four front panel
securing screws and the front-panel. Install the panel mount installation plate
(Cat. No. 16411). Note that the probe receptacle in a panel-mount application
may not be easily accessible behind the panel. For many panel-mount
applications, it may be advisable to wire the probe connections out to an
optional junction box near the probe location. The junction box contains a
receptacle for plugging in the probe (see
box should be no more than 200 feet from the monitor.
To attach the panel mount kit brackets, refer to
proceed as follows:
1. Attach the Z-brackets (Cat. No. x) using 1/4-20 x 0.25" L hex bolts at the
back of the meter. Do not completely tighten the bolts at this time.
2. Remove the front panel (4 screws) and position the Enclosure Plate.
3. Reattach the front panel with the Enclosure Plate sandwiched
underneath it.
4. Attach the Enclosure Plate to the Z-brackets with four screws and tighten
all screws to finish the assembly.
Figure 11
on
page
18). The junction
Figure 5
and
Figure 6
16116Install.fm
and
Advertisement
Table of Contents
