Suggested Part Replacement Time
The table shows approximate replacement time of components that are exposed to
natural wear and tear. In order to maintain the printer in good condition and to provide
the highest priting quality, it's advisable to replace particular components after an
appropriate period of time indicated in the table.
NOTE! The lifespan of particular components highly depends on the type of
filaments you use most often.
Nozzle
Hotend
Every 300
Every 400
working hours
working hours
Perforated
Extruder
Plate
Cable
Every 700
Every 500
working hours
working hours
Heater and T
Extruder
hermocouple
Fans 40×40
Every 400
Every 500
working hours
working hours