Nokia 7368 Product Manual page 66

Install a G-240W-J indoor ONT
8
9
10
11
12
66
Connect the fiber optic cable with SC/APC adapter into the SC/APC
6
connector; see Figure
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC fiber
optic pigtail cable.
Install the power supply according to manufacturer specifications.
7
Note — Observe the following:
•
Units must be powered by a Listed or CE approved and marked limited
power source power supply with a minimum output rate of 12 VDC, 3 A.
Connect the power cable to the power connector.
Power up the ONT unit by using the power switch.
If used, enable the Wi-Fi service.
Locate the WLAN button; see Figure
i
Press the WLAN button to change the status of the Wi-Fi service.
If used, enable the WPS.
Locate the WPS button; see Figure
i
Press the WPS button to change the status of the WPS.
Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
3FE-48009-AAAA-TCZZA
7368 ISAM ONT G-240W-J Product Guide
16 for the location of the SC/APC connector.
16 for the location of the WLAN button. ii
16 for the location of the WPS button. ii
Issue: 01