Figure 16 G-240W-J Ont With Connections And Key Mounting Holes - Nokia 7368 Product Manual

7368 ISAM ONT G-240W-J Product Guide
Figure 16 G-240W-J ONT with connections and key mounting holes
Issue: 01
Attach the wall mounting keyholes on the ONT.
i
Drill two holes into the wall where the ONT will be mounted. If possible, mount the
ii
ONT on a wall stud.
Do not drive the screw into the wall completely. Leave approximately 1/8 in. (6 mm)
between the screw head and the wall surface.
Drive the mounting screws into the holes.
iii
The recommended length of the mounting screw is 1.15 in. (3.8 cm).
Slide the wall mount keyholes on the ONT enclosure down over the mounting screws
iv
until the ONT is securely seated.
Review the connection locations, as shown in Figure 16.
3
Connect the Ethernet cables to the RJ-45 ports; see Figure
4
location of the RJ-45 ports.
Route the POTS cables directly to the RJ-11 ports as per local practices.
5
The POTS port to the left is labeled 1 for Line 1 while the port on the right is labeled 2 for
Line 2, as shown in Figure 16.
3FE-48009-AAAA-TCZZA
Install a G-240W-J indoor ONT
16 for the
65