RoboLabs ROBOSUGAR CPA-10 Operation Manual page 14

ROBOSUGAR CPA-10(A) Sep-18
3.2 MAINTENANCE ORDER
8
KETTLE CLEANING
Pour not more than 4 liters of water in the kettle, close the kettle with lid
provided in the delivery set, and turn the main switch in ON position.
Wait until water is started to boil; let it boil for a few minutes, so hot
water steam will be able to fill the kettle properly. Turn off the machine
and let the kettle to cool down.
In case of severe carbon build ups, use special cleaning product (Heat
N Kleen or similar).
SCRAP TRAY CLEANING
Take out scrap tray, remove scrap, then wash the tray with warm water.
PADDLE CLEANING
From the kettle's side, there is a protective paddle laid under the
conveyor belt. During machine operation, a lot of small particles of
caramel and popcorn are accumulated onto this part. Take it out and
wash with warm water.
CONVEYOR DRIVE SHAFT CLEANING
It is important to clean conveyor drive shaft area once in a week or more
often. To get access to the area, remove four wing nuts and take
protective shroud out. It is convenient to clean shaft's gears with stiff
bristle brush. Once the area is cleaned, put silicone scraper, mind its
position (refer to section 2.3).
8
The machine must be plugged in for kettle cleaning procedure.
14