TROUBLESHOOTING
Service and repairs should only be performed by an authorized service center.
Symptom:
Machine does not run! No power to the machine!
Problem:
Batteries not correctly installed in machine.
Solution:
Install batteries correctly in machine. Follow instructions give above (see page 8 + 11).
Problem:
Internal fuse or FI protection switch tripped.
Solution:
Check internal fuse and FI protection switch.
Problem:
Power supply interrupted.
Solution:
Have power supply checked by authorized technician.
Problem:
Frayed cables, damaged plug or loose internal wiring.
Solution:
Have an authorized service technician check cord and replace if necessary. Have an
authorized service technician open switch panel and check for loose wire connection.
Problem:
Brush motor protection switch tripped.
Solution:
Allow motor to cool, press motor protection switch pushbutton, put less clean water into
the tank.
Problem:
Discharge signal transmitter has activated.
Solution:
Charge batteries.
Symptom:
Insufficient vacuuming power! Loss of vacuum!
Problem:
Tank cover/dome not properly seated or gasket on dome damaged/worn out.
Solution:
Reseat tank cover correctly or replace gasket.
Problem:
Vacuum hose and squeegee assembly is clogged up with dirt, or hose is not correctly
inserted into squeegee assembly.
Solution:
Remove dirt and re-attach vacuum hose.
Problem:
Filter in recovery tank is clogged up.
Solution:
Clean filter with clean water.
Problem:
Recovery tank drain hose not properly closed.
Solution:
Close properly.
Problem:
Wrong angle of squeegee assembly.
Solution:
Adjust angle of squeegee assembly.
Problem:
Defective vacuum motor.
Solution:
Have an authorized service technician replace vacuum motor.
Symptom:
Poor cleaning performance!
Problem:
Worn brush or pads.
Solution:
Replace brush or pads.
Problem:
Improper chemical for cleaning job or improper dilution.
Solution:
Change chemical or adjust dilution.
Safety, Operation and Maintenance Manual for Falcon (RA 530 B); Version 1.0
WARNING
15
Need help?
Do you have a question about the Falcon and is the answer not in the manual?